Markem LP275 Hot Stamp Label Press

Description

This is a Markem LP275 Hot Stamp press.
It's capable of running four different colors of foil at one time Also it runs at approximately 5,000 impressions an hour. It has a 3 7/8" X 3 7/8" die cutting area This press was taken off line 6 years ago it was running when it was disconnected There is no reason that if connected to 220 single phase that it would not run The heating element was working and only two years old when the press was taken off line. The press has all the parts it needs The removable print head is there, Along with the die cutting head with full adjustment. The pinch rolls are there along with a numbering unit mounting block. This press was on wheels. We removed them to set it on the pallet they will be included. The press has been in storage for over 6 years it needs to be cleaned and lubricated before trying to run labels, It does have some rust and old grease. The rubber O-rings that hold the cores need to be replaced they are rubber O-rings that can be bought from any seal or bearing supplier. If you have run one of these then you know what needs to be done. If you are not familiar with this type of hot stamp label press there are a couple of people selling manuals on the internet. I have ran this type of press but it was over 30 years ago I have forgotten most of what I knew. Looking over the press I believe it's all there but I could have missed an adjusting screw or some small part. But If you ask questions I will answer them to the best of memory and or looking at the press. The buyer will pay for freight and make all
arrangements
.  We will strap it to a pallet and shrink wrap it for free However if a crate has to be made there will be a 160.00 lumber charge I am guessing 600 pounds on the pallet and there would have to be a lift gate pick up We do not have a forklift for loading if you are local and want to come look at it that can be arranged. Just message me. This is one of two presses we have up for auction check out the other one we have. it's the same model press and we should be able to fit both of them on the same pallet
.